KEISOKU GIKEN LOAD EDGE Series User Manual

Load Edge Series
Parallel Operations 107
9.1.7 Reset Parallel operation
When reset the parallel operation, select [NORMAL] at the menu.
Push “F1” key Push “F3” key
Push “F3” key Push “F3” key Push “ENT” key
Push “MENU” (or “CE”) key
Slave
When returning from parallel operation to single operation, turn all the power switches OFF
then disconnect BOOSTER cables.
Turn off the power from the higher slave numbered unit.
In case of turning off all units, or setting the MASTER unit as single operation,
you set all units as single operation ( set [NORMAL] mode on the menu page 1).
C
A
U
T
I
O
N

KEISOKU GIKEN LOAD EDGE Series Specifications

General

Brand	KEISOKU GIKEN
Model	LOAD EDGE Series
Category	Measuring Instruments
Language	English