KEISOKU GIKEN LOAD EDGE Series - CR Mode

Load Edge Series
50 Operations for Load Mode
5.6 CR mode
In this CR mode, load current changes in proportion to the load
voltage as if resistor is used. This mode is adapted to a general
load test.
(1) Press the rotary knob to set mode select condition. And then turn the knob until “CR” is
displayed as shown below.
(2) Input setting value by ten keys, and then press ENT key to confirm the setting value.
(3) Press ON/OFF key to select ON to start flowing the load current according to this
setting.
Fig. 5-6-1 Operation in CR mode
Set the remote sensing selector switch at “EXT” position when in remote sensing mode.
Set at “INT” position when not in use.
Contrary may cause malfunction on measurement, setting and /or power limiting.
For detailed about the connection refer to →“ 2.2 Cable Connection”.
･When CR mode is already set, CR setting value can be changed by inputting the value with ten
keys and the ENTER key.
･When load mode is changed from CR mode, the CR setting value is stored for future use.
･When CR setting value is less than minimum value, the minimum (resistance) value is
automatically set.
I
n
p
u
t
V
o
l
t
a
g
e
S
e
t
C
u
r
r
e
n
t
L
o
a
d
C
u
r
r
e
n
t
I
V
W
A
R
N
I
N
G
M
o
d
e
S
e
l
e
c
t
E
n
t
e
r
v
a
l
u
e
S
e
t
L
o
a
d
O
N
7
4
1
0
.
2
5
8
9
6
3
C
E
O
N
/
O
F
F
E
N
T
N
O
T
E