Load Edge Series
Specification 117
Chapter 10 Specifications
The specifications of this product are as follows unless otherwise specified.
・Warm up time 30 min. or more
・Temperature: 23℃±5℃, Humidity 70% or less.
10.1 General
*) If you have alarm, remove the cause as soon as possible because a function which detect over
voltage and reverse connection can‟t protect a main circuit.
10.2 Measurement section
forced air cooling by a fan
215(W)×128.6(H)×420(D)
excluding raised portions
less than 150VA
(at AC100V)
conforms to the IEEE488.1
protect the load section by setting no load condition
alarm only,the load section is NOT protected
Protection alarm functions ELZ-175
alarm only, the load section is NOT protected
protect the load section by limiting the power
protect the load section by limiting the current
4.0000V 30.000V
0.1mV 1.0mV
DC voltage mesurement ELZ-175
±0.05% of rdg. ±0.05% of fs.
±0.2% of rdg. ±0.1% of fs.
DC current mesurement ELZ-175
Calculation method [Volt. measured × Curr. measured]
*1 warranted for six months in the conditions of le peripheral temp. 23±5℃ and humidity 70% or less.
*2 Meas time when the same meas mode and the same range.
*3 there are two ranged for the curr. meas. Spec depends on the selected range.
*4 readback data is the absolute value of measured data
To Next Page
Loading...
Need help?
General