Load Edge Series
72 Operations for Measurement Mode
NOISE Noise by RC-02A
RIPPLE Ripple by RC-02A
Note: RC-02A module can be provided by a factory option of this product.
･When CV mode is selected , connect remote sense cables to the sense terminals. Otherwise this
product cannot work properly.
･For detailed about the connection refer to →“ 2.2 Cable Connection”.
6.2 Sampling rate
To cancel the influence of ham noise, you can select sample frequency of A/D converter in this
product. Usually you select the same frequency as the commercial line.
・ Select frequency
To select sample frequency, display MEASURE SETUP menu.
Press F3 key to display sampling frequency window as shown below.
Press F3 key or turn the knob to select 50Hz or 60Hz.
Press ENT key or the knob to confirm the frequency you selected.
Fig. 6-2-1 setting for sampling rate
6.3 Voltage / Current ranges
Note; when you change ranges of this product, not only measurement but also load setting
will be influenced by the setting. Please pay attention to the specifications of each range
before you use this product.
To change ranges, you can change from any menu except while you are setting I/O setting.
(1) Voltage range setting
Press the rotary knob twice quickly.
To Next Page
Loading...
Need help?
General