Keysight u2722a - Status:questionable:ptransition

10 STATus Subsystem
100 Keysight U2722A/U2723A Programmer’s Reference
STATus:QUEStionable:PTRansition
Syntax
STATus:QUEStionable:PTRansition <value>
This register serves as a polarity filter between the Questionable Condition and
Questionable Event registers. When a bit in the Questionable PTR register is set
to 1, then a 0-to-1 transition of the corresponding bit in the Questionable
Condition register causes that bit in the Questionable Event register to be set.
STATus:QUEStionable:PTRansition?
These command reads the value of the Questionable PTR (Positive-Transition)
register.
Parameter
For example, to enable bit 4, the corresponding decimal value would be 16.
Remarks
– The following table lists the bit definitions for the Questionable Status
registers.
–The STATus:PRESet command will set all bits in the PTR register to 1.
NOTE
For more information on the SCPI Status System, refer to Chapter 2, “Status
system diagram” on page 21.
Item Type Range of values Defaul t value
<value> NR1 A decimal value which corresponds to the binary-weighted
sum of the bits in the register (refer to the table below).
Preset = 16
Bit number Decimal value Definition
0 to 3 Not Used 0 0 is returned.
4 OT 16 The over-temperature protection has tripped.
5 to 15 Not Used 0 0 is returned.