Keysight u2722a - Sense:sweep:points

8 SENSe Subsystem
46 Keysight U2722A/U2723A Programmer’s Reference
SENSe:SWEep:POINts
Syntax
SENSe:SWEep:POINts <points>, (@<ch>)
This command defines the number of points in a measurement on models that
have measurement controls. Programmed values can range from 1 to 4096 (4K).
SENSe:SWEep:POINts? (@<ch>)
This will query the number of points set.
Parameters
Returned Query Format
<NR1>
The query command returns the number of points for each channel specified.
Examples
The following command specifies 1000 measurement points on channel 1.
SENS:SWE:POIN 1000, (@1)
The following query returns the number of measurement points set on channel 2.
SENS:SWE:POIN? (@2)
See Also
SENSe:SWEep:TINTerval
Item Type Range of values Defaul t value
<ch> NR1 1 through 3 Required parameter
<points> NR1 1 to 4096 (4K) Required parameter