Keysight u2722a - Status:questionable:enable

10 STATus Subsystem
94 Keysight U2722A/U2723A Programmer’s Reference
STATus:QUEStionable:ENABle
Syntax
STATus:QUEStionable:ENABle <value>
The Enable register is a mask for enabling specific bits from the Questionable
Event register to set the questionable summary bit (QUES) of the Status Byte
register. This bit (bit 3) is the logical OR of all the Questionable Event register bits
that are enabled by the Questionable Status Enable register.
STATus:QUEStionable:ENABle?
This command reads the value of the Questionable Status Enable register.
Parameters
For example, to enable bit 4, the corresponding decimal value would be 16.
Remarks
– The following table lists the bit definitions for the Questionable Status
registers.
–The STATus:PRESet command will clear all bits in the enable register.
NOTE
For more information on the SCPI Status System, refer to Chapter 2, “Status
system diagram” on page 21.
Item Type Range of values Default value
<value> NR1 A decimal value which corresponds to the binary-weighted
sum of the bits in the register (refer to the table below).
Preset = 0
Bit number Decimal value Definition
0 to 3 Not Used 0 0 is returned.
4 OT 16 The over-temperature protection has tripped.
5 to 15 Not Used 0 0 is returned.