Keysight u2722a - [Source:]Memory:configure:points

SOURce Subsystem 9
Keysight U2722A/U2723A Programmer’s Reference 57
[SOURce:]MEMory:CONFigure:POINts
Syntax
[SOURce:]MEMory:CONFigure:POINts <start>,<end>,<loop>, (@<ch>)
This command sets the start point, end point, and loop count for the channel
active memory list.
[SOURce:]MEMory:CONFigure:POINts?
Queries the start point, end point, and loop count value for the channel active
memory list.
Parameter
Remarks
This command is only applicable for the U2723A USB Modular SMU. If the set
value is larger than the number of commands in the memory list, or the end point
is larger than the start point,the input is invalid and error –222 is displayed.
Returned Query Format
<NR1>,<NR1>,<NR1>
Example
MEM:CONF:POIN 1,100,1(@1)
MEM:CONF:POIN?(@1)
See Also
CONFigure:SSI
Item Type Range of values Default value
<ch> NR1 1 through 3 Required parameter
<start> NR1 1 to 200 Required parameter
<end> NR1 1 to 200 Required parameter
<loop> NR1 1 to 1000 Required parameter