2 SCPI Status Registers
22 Keysight U2722A/U2723A Programmer’s Reference
Operation Status Registers
These registers record signals that occur during normal operation. The group
consists of a Condition, PTR/NTR, Event, and Enable register. The outputs of the
Operation Status register group are logically-ORed into the OPERation summary
bit (7) of the Status Byte register.
Bit Definitions: Operation Status Registers
All bits in the Operation Enable register will be cleared when you execute the
STATus:PRESet command. This command presets the Operation Status registers.
Bit number Decimal value Definition
0 to 1 Not Used 0 0 is returned.
2 DTG1-tran 4 The transient system has received a trigger signal and operation is running
in channel 1
3 DTG2-tran 8 The transient system has received a trigger signal and operation is running
in channel 2
4 DTG3-tran 16 The transient system has received a trigger signal and operation is running
in channel 3
5 WTG1-tran 32 The transient system is waiting for a trigger in channel 1.
6 WTG2-tran 64 The transient system is waiting for a trigger in channel 2.
7 WTG3-tran 128 The transient system is waiting for a trigger in channel 3.
8 to 15 Not Used 0 0 is returned.
To Next Page
Loading...
