Keysight u2722a - Status:preset

10 STATus Subsystem
92 Keysight U2722A/U2723A Programmer’s Reference
STATus:PRESet
Syntax
STATus:PRESet
This command sets all defined bits in the status system's PTR registers and clears
all bits in the NTR and Enable registers.
Parameters
Example
The following command presets the Operation and Questionable Status registers.
STAT:PRES
Operation register Questionable register Definition
STAT:OPER:ENAB STAT:QUES:ENAB 0 – all bits disabled.
STAT:OPER:NTR STAT:QUES:NTR 0 – all bits disabled.
STAT:OPER:PTR 252 – all defined bits enabled.
STAT:QUES:PTR 16 – all defined bits enabled.