Keysight u2722a - [Source:]Voltage:limit

SOURce Subsystem 9
Keysight U2722A/U2723A Programmer’s Reference 79
[SOURce:]VOLTage:LIMit
Syntax
[SOURce:]VOLTage:LIMit <value>, (@<ch>)
This command sets the maximum bounds on the output voltage value. Output
voltage level will be clamped to the limit value if the voltage level has exceeded
the bounds set.
[SOURce:]VOLTage:LIMit? (@<ch>)
This will query the set voltage limit.
Parameters
Returned Query Format
<NR3>
Examples
The following command sets the voltage limit to 0.5 V on channel 1.
VOLT:LIM 0.5, (@1)
The following query returns the programmed voltage limit on channel 1.
VOLT:LIM? (@1)
Typical Response: +5.000000E-01
See Also
[SOURce:]CURRent:LIMit
Item Type Range of values Default value
<ch> NR1 1 through 3 Required parameter
<value> NRf The maximum value is dependent on the
voltage range set
Required parameter