14 Error Messages
134 Keysight U2722A/U2723A Programmer’s Reference
The execution errors are listed in the table below.
Table 14-3 Execution errors
Error Execution errors (these errors set the Standard Event Status register bit #4)
–200 Execution error
Generic syntax error.
–210 Trigger error
Generic trigger error.
–211 Trigger ignored
A Group Execute Trigger (GET) was received but the trigger was ignored.
–220 Parameter error
A data element related error occurred.
–221 Settings conflict
A data element could not be executed because of the present instrument state.
–222 Data out of range
A data element could not be executed because the value was outside the valid range.
–223 Too much data
A data element was received that contains more data than the instrument can handle.
–224 Illegal parameter value
An exact value was expected but not received.
–225 Out of memory
The device has insufficient memory to perform the requested operation.
–230 Data corrupt or stale
Possibly an invalid data. A new reading was started but not completed.
–231 Data questionable
The measurement accuracy is in question.
–240 Hard ware error
The command could not be executed due to a hardware problem with the instrument.
–241 Hard ware missing
The command could not be executed due to missing hardware, such as an option.
To Next Page
Loading...
