10 STATus Subsystem
90 Keysight U2722A/U2723A Programmer’s Reference
STATus:OPERation:PTRansition
Syntax
STATus:OPERation:PTRansition <value>
This register serves as a polarity filter between the Questionable Condition and
Questionable Event registers. When a bit in the Questionable PTR register is set
to 1, then a 0-to-1 transition of the corresponding bit in the Questionable
Condition register causes that bit in the Questionable Event register to be set.
STATus:OPERation:PTRansition?
These reads the value of the Questionable PTR (Positive-Transition) register.
Parameters
For example, to enable bit 5 (decimal value = 32) and bit 6 (decimal value = 64),
the corresponding decimal value would be 96 (32 + 64).
For more information on the SCPI Status System, refer to Chapter 2, “Status
system diagram” on page 21.
Item Type Range of values Default value
<value> NR1 A decimal value which corresponds to the binary-weighted sum
of the bits in the register (refer to the table below).
Preset = 252
To Next Page
Loading...
