Keysight u2722a - Page 91

STATus Subsystem 10
Keysight U2722A/U2723A Programmer’s Reference 91
Remarks
– The following table lists the bit definitions for the Operation Status registers.
–The STATus:PRESet command will set all bits in the PTR register to 1.
Returned Query Format
<NR1>
The returned value is the binary-weighted sum of all bits set in the register.
Examples
The following command enables bits 5 (decimal value = 32) and 6 (decimal
value = 64) in the PTR register.
STAT:OPER:PTR 96
The following query returns the bits enabled in the register.
STAT:OPER:PTR?
Typical Response: +96
See Also
STATus:OPERation:NTRansition
STATus:PRESet
Bit number Decimal value Definition
0 to 1 Not Used 0 0 is returned.
2 DTG1-tran 4 The transient system has received a trigger signal and operation is running in channel 1.
3 DTG2-tran 8 The transient system has received a trigger signal and operation is running in channel 2.
4 DTG3-tran 16 The transient system has received a trigger signal and operation is running in channel 3.
5 WTG1-tran 32 The transient system is waiting for a trigger in channel 1.
6 WTG2-tran 64 The transient system is waiting for a trigger in channel 2.
7 WTG3-tran 128 The transient system is waiting for a trigger in channel 3.
8 to 15 Not Used 0 0 is returned.