5 INITiate Subsystem
34 Keysight U2722A/U2723A Programmer’s Reference
INITiate[:IMMediate]:TRANsient
Syntax
INITiate[:IMMediate]:TRANsient (@<ch>)
This command enables the transient trigger system. When a transient or output
trigger is initiated, an event on a selected trigger source causes the specified
triggering action to occur. If the trigger system is not initiated, all triggers are
ignored.
Parameter
Example
INIT:TRAN (@1)
See Also
ABORt:TRANsient
Item Type Range of values Default value
<ch> NR1 1 through 3 Required parameter
To Next Page
Loading...
