SENSe Subsystem 8
Keysight U2722A/U2723A Programmer’s Reference 49
SENSe:VOLTage[:DC]:NPLCycles
Syntax
SENSe:VOLTage[:DC]:NPLCycles <cycles>, (@<ch>)
This command sets the number of power line cycles taken for the voltage
measurement. The value is coupled to APERture by the equation:
APERture = NPLCycles/selected line frequency.
SENSe:VOLTage[:DC]:NPLCycles? (@<ch>)
Query the number of power line cycles taken for the voltage measurement in the
defined channels.
Parameters
Returned Query Format
<NR1>
Examples
SENS:VOLT:NPLC 10, (@1)
SENS:VOLT:NPLC? (@1)
See Also
SENSe:CURRent[:DC]:APERture?
SENSe:CURRent[:DC]:NPLCycles
Item Type Range of values Defaul t value
<ch> NR1 1 through 3 Required parameter
<cycles> NR1 0 to 255 Required parameter
To Next Page
Loading...
