9 SOURce Subsystem
52 Keysight U2722A/U2723A Programmer’s Reference
[SOURce:]CURRent
Syntax
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <current>,
(@<ch>)
Sets the actual current magnitude of the unswept output signal in terms of the
present operating units. The units are set to the default value, or alternately to a
different value under the UNIT subsystem. The AMPLitude may be used to specify
the level for either a time varying or non-time varying signal.
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]? (@<ch>)
Queries the sourced current.
Parameters
Returned Query Format
<NR3>
Examples
The following command sets the output current to 0.02 A on channel 1.
CURR 0.02, (@1)
The following query returns the programmed current level on channel 1.
CURR? (@1)
Typical Response: +2.000000E-02
See Also
[SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude]
[SOURce:]CURRent:RANGe
[SOURce:]VOLTage
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]
Item Type Range of values Defaul t value
<ch> NR1 1 through 3 Required parameter
<current> NRf The maximum value is dependent on the current range set Required parameter
To Next Page
Loading...
