Safety features of your vehicle
404
Child Restraint System (CRS)
To install a child restraint system on
the rear seats, do the following:
1. Place the child restraint system
on a
r
ear seat and route the lap/
shoulder belt around or through
the child restraint, following the
restraint manufacturer's instruc
-
tions.
Be sure the seat belt webbing is
not twisted.
2. Fasten the lap/shoulder belt latch
in
to the bu
ckle. Listen for the dis
-
tinct "click" sound.
Position the release button so
that i
t is easy to access in case of
an emergency.
3. Pull the shoulder portion of the
se
at
belt all the way out. When
the shoulder portion of the seat
belt is fully extended, it will shift
the retractor to the "automatic
locking" (child restraint) mode.
4. Slowly allow the shoulder portion
of the
sea
t belt to retract and lis
-
ten for an audible "clicking" or
"ratcheting" sound. This indicates
that the retractor is in the "auto
-
matic locking" mode. If no distinct
sound is heard, repeat steps 3 and
4.
To Next Page
Loading...
