Features of your vehicle
385
Mirrors
Programming HomeLink
䳜 When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
䳜 It is recommended that a new
battery be placed in the hand-
held transmitter of the device
being programmed to HomeLink
for quicker training and accurate
transaxle of the radio-frequency
signal.
䳜 Some
vehicles may require the
POWER button to be ACC (or
"Accessories") position for pro
-
gramming and/or operation of
HomeLink
.
䳜 In the event that there are still
pr
ogramming difficulties or ques
-
tions after following the pro
-
gramming steps listed below,
contact HomeLink
at:
www.homelink.com or 1-800-
355-3515.
Standard programming
To train most devices, follow these
instructions:
1. Press and release (1), (2) or (3)
button
.
䳜 If the indicator (4) is turned ON
in Ora
nge, go to Step 3 since it
is a new programming.
䳜 If the indica
tor
(4) is continu
-
ously turned ON or flashes in
Green rapidly several times, go
to Step 2 since it is a pro
-
grammed button.
2. Press and hold the button you
wish to program about 15-25
seco
nds until the LED flashes in
Orange for several times.
3. Hold the Garage Door Opener
Original
T
ransmitter (OT) near the
HomeLink Mirror.
4. Press the Origi
n
al Transmitter
(OT) button until the indicator (4)
is turned continuously ON or
flashes in Green for approxi
-
mately 10 seconds and it indi
-
cates the programing is
completed.
To Next Page
Loading...
