39
5
5
Features of your vehicle Mirrors
䳜 Some garage door openers
require to press the programed
button on the mirror up to three
times right after the programing
is just completed to operate the
garage door.
䳜 The indicator (4) is turned ON in
Orange and flashes for about
60seconds, during the programing
mode and if a programing is not
succeeded within the 60 seconds,
the programing mode will be
abort.
HomeLink
should now activate
your rolling code equipped device.
Gate operator & Canadian pro
-
gramming
During programming, your hand
-
held-transmitter may automati
-
cally stop transmitting. Continue to
press the Integrated HomeLink
Wireless Control System button
while you press and re-press
("cycle") your handheld transmitter
every two seconds until the fre
-
quency signal has been learned.
The indicator light will flash slowly
an
d then rapidly after several sec
-
onds upon successful training.
Operating HomeLink
䳜 Press and release one of the
HomeLink buttons (1, 2 or 3) that
programed.
The HomeLink indicator (4) will
op
er
ate as below:
䳜 Indicates Green and is continu
-
ously ON (Fixed Code Garage
Door Opener)
䳜 Flashes in Green rapidly (Roll
-
ing Code Garage Door Opener)
To Next Page
Loading...
