Kidde ARIES

August 2013 3-76 P/N 06-236530-001
3-2.5.2.4.59 How to Reset Remote-Annunciator Modules
Purpose: To remove any off-normal indications from remote-
annunciator modules that did not clear after a reset command
3-2.5.2.4.60 How to Enable Battery Supervision
Purpose: To restore battery supervision that was disabled by the
procedure in Paragraph 3-2.5.2.4.61.
3-2.5.2.4.61 How to Disable Battery Supervision
Purpose: To disable battery supervision for systems that are not using
a standby battery for secondary power.
Step Action Result
1 Press 0 Key Initiate menu access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press "Scroll" Key Access additional options
5 Press 7 Key Select "Control Modules" option
6 Press 3 Key Select Reset ATM/RDCM
7 Press 1 Key Execute reset command
8 Press "Backspace" Key (as required) Exit Menu System
Step Action Result
1 Press 0 Key Initiate Menu Access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press "Scroll" Key three times Access additional Set-Menu options
5 Press 9 Key (Installer) Select "Battery" option
6 Press 3 Key Select “Disable Battery“ option
7 Press 1 Key, then press “Enter” Key Select “Enable Battery” Connection
8 Press "Backspace" Key (as required) Exit Menu System
Step Action Result
1 Press 0 Key Initiate menu access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press "Scroll" Key three times Access additional Set-Menu options
5 Press 9 Key (Installer) Select "Disable-Battery" option
6 Press 2 Key, then press “Enter” Key Select Disable Battery Connection
7 Press "Backspace" Key (as required) Exit Menu System
8 Press "Backspace" Key (as required) Exit Menu System