Kidde FX-64

Chapter 2: Front panel programming
114 P/N 3102352-EN • REV 005 • ISS 28DEC18
Loop event
Printer
Dialer
NET (1-8) CID
Loop
4 initialization Yes
None
No 000
Loop
4 fault (disable) Yes
None
No 500
Loop
4 fault (trouble) Yes
Acct 1
Yes 331
Loop
4 card fault (disable) (e.g., line fault) Yes
None
No 500
Loop
4 card fault (trouble) (e.g., line fault) Yes
Acct 1
No 333
Loop
4 Uncfgrd alarm (disable) Yes
None
No 500
Loop
4 Uncfgrd alarm (trouble) Yes
Acct 1
No 110
Loop
4 Uncfgrd trbl (disable) Yes
None
No 500
Loop
4 Uncfgrd trbl (trouble) No
None
No 331
Loop
4 over limits Yes
None
No 331
Loop
4 address zero Yes
None
No 331
To program loop events:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3. Choose Loop Events.
4. Select the loop event.
5. Choose Event Notification.
6. Set the event notification. See the default settings in the table above.
Printer: Yes or No. Specifies if event information is printed.
Dialer:
• Acct 1 & 2: Event information is sent to both dialer accounts
• Acct 1: Event information is sent to dialer account one
• Acct 2: Event information is sent to dialer account two
• None: Event information is not sent to the dialer
NET (1-8): Yes or No. Specifies if event information is sent to the connected network
CID: Contact ID event code (000 to 999)
7. When finished, choose Save.
8. Repeat steps 6 to 9 for each loop event.
9. Press the Menu button to exit menu mode, or continue programming.