Chapter 5: Diagnostics, maintenance, and testing
176 P/N 3102352-EN • REV 005 • ISS 28DEC18
• All device activations are latched until walk test is ended or the panel is reset. When walk
test is ended, it takes approximately eight seconds for the devices to restore. If the device
being tested is in a zone and does not restore, the zone does not reset.
• If auxiliary power is resettable, the auxiliary power is interrupted while the zone is reset.
• Input zones programmed as waterflow with retard require 10 to 15 seconds of activation to
initiate the test signals.
• Devices programmed as alarm verify and not in test mode go directly into alarm if activated
(the alarm verification process is bypassed).
• Restore each device after testing. For example, if you are testing a pull station, reset the
pull station before testing the next device.
The panel terminates walk test if:
• The zone or device being tested remains inactive for 30 minutes.
• The walk test is stopped by the user.
To start a walk test:
1. Press the Menu button and choose Test.
2. Choose Walk Test Silent or Walk Test Audible.
3. Enter a level one password.
4. Choose either All Devices or Zone.
5. If you chose Zone, enter the zone ID for the zone you are going to conduct the walk test.
6. Choose Start.
7. Conduct your walk test.
8. Press Cancel to return to the previous menu.
— or —
Press the Menu button to exit menu mode.
Note: To see the activation and restoration of all walk test events, the panel must be reset
prior to ending the walk test. Once the reset is complete, you can end the walk test and view a
walk test report.
To end a walk test:
1. Press the Menu button and choose Test.
2. Choose Walk Test Silent or Walk Test Audible.
3. Choose either All Devices or Zone.
4. If you chose Zone, enter the zone ID of the zone for which you are going to end the walk
test.
To Next Page
Loading...
