Kidde FX-64

Chapter 2: Front panel programming
P/N 3102352-EN • REV 005 • ISS 28DEC18 45
[1] Active3 is an activation from a COD device, or an activation from the secondary element of a dual element
detector (single addr
ess), such as PCD, HCD, or PHCD. See “Device type descriptions” on page 47.
Default contact ID event codes
Contact ID codes are used to report events that take place in the fire alarm system to a central
monitoring station (CMS) via a dialer or over a network. The following table lists the default
Contact ID (CID) codes for panel and loop events. Some events do not have CID codes. You
can change the default code for an event or assign a code to an event that does not have one.
See “Event programming” on page 110.
Table 10: Contact ID event codes
Event
CID
AC power (disable)
500
AC power (trouble)
301
Alarm active
110
Alarm ON
115
Annunciator trouble
334
Aux. power 1 (disable)
500
Aux. power
1 (trouble) 312
Aux. power 2 (disable)
500
Aux. power 2 (trouble)
312
Battery charger (disable)
500
Battery charger (trouble)
309
Battery low (disable)
500
Battery low (trouble)
302
Battery missing (disable)
500
Battery missing (trouble)
311
Clear
history 621
CO detected (alarm)
162
Common alarm
110
Common disable
500
Common monitor
140
Common supervisory
200
Common trouble
373
Common trouble for network dialer
373
Event
CID
Common trouble for telco dialer
373
Date
625
Device trouble
373
Device
disable 570
Device pre alarm
118
Device alarm verify
118
Device maintenance alert
393
Device test
614
Dialer disable/remote disconnect
551
Dialer line 1 fault (disable)
500
Dialer line 1 fault (trouble)
351
Dialer line 2 fault (disable)
500
Dialer
line 2 fault (trouble) 352
Dialer deliver fail
354
Dialer normal test
602
Dialer abnormal test
608
Dialer configuration
354
Drill
601
Duct active
116
Ground fault (disable)
500
Ground fault (trouble)
310
Heat active
114
Internal fault
307
IP
Gateway Trouble 354