Chapter 2: Front panel programming
P/N 3102352-EN • REV 005 • ISS 28DEC18 85
Programming in-suite signal silence
In-suite signal silence is programmed using two separate menus:
• Configure the elapse timer for in-suite signal silence by displaying the Program > Advanced
Program > Panel Operation menu.
• The function is enabled for individual correlation groups through the Program > Advanced
Program > Loop Configuration > Correlation Groups menu.
This section provides instructions for setting both in-suite signal silence options.
Note: When setting up correlation groups for in-suite signal silence, the group’s activation
count must be set to 1. See “Setting a correlation group’s activation count” on page 82.
To enable in-suite signal silence for a correlation group:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3 Choose Loop Configuration.
4. Choose Correlation Groups and enter the number of the correlation group. (Values range
from 001 to 199.)
5. Choose Suite Sig Sil.
6. Select:
Yes to enable in-suite signal silence.
No to disable it.
7. Choose Save.
To set the in-suite signal silence elapse timer:
1. Press the Menu button and choose Programming.
2. Choose Panel Operation and enter the level 2 password.
3. For the Suite Sig Sil option, enter a value from 1 to 10 minutes (the default is 10). To
disable in-suite signal silence, set this option to Off.
This is a global option that sets the shutdown period during which “in suite” evacuation signals
outside the alarm zone remain silenced.
Programming fast groups for sounder bases
For UL/ULC Listing, alarms are required to sound within 10 seconds after a fire is detected.
This can be difficult to achieve in large systems with hundreds of sounders, unless the
sounders are properly grouped.
To Next Page
Loading...
