Abbreviations used in this manual
The abbreviations used in this manual are explained in the table below.
Symbols used in this manual
danger to personnel from
electricity and its effects
general warning
general instructions
mechanical hazard
ð p.
see page (cross-ref.) l special emphasis
Keys on the servo amplifier panel :
U
press once : move up one menu item, increase number by one
press twice in rapid succession : increase number by ten
U
press once : move down one menu item, decrease number by one
press twice in rapid succession : decrease number by ten
U
U
hold right key pressed, and then press left key as well :
to enter number, “Return” function
SERVOSTAR
®
601...620 Installation Manual 9
Kollmorgen 03/04 Abbreviations / symbols
Abbrev. Meaning
AGND Analog ground
AS Restart Lock, option
BTB/RTO Ready to operate
CAN Fieldbus (CANopen)
CE Communité Européenne (EC)
CLK Clock signal
COM Serial interface for a PC-AT
DGND Digital ground
DIN German Institute for industrial Standards
Disk Magnetic storage (diskette, hard disk)
EEPROM Electrically erasable programmable memory
EMC Electromagnetic compatibility
EMI Electromagnetic interference
EN European standard
ESD Electrostatic discharge
IEC International Electrotechnical Commission
IGBT Insulated Gate Bipolar Transistor
INC Incremental Interface
ISO International Standardization Organization
LED Light-emitting diode
MB Megabyte
MS-DOS Operating system for PC-AT
Abbrev Meaning
NI Zero pulse
NSTOP Limit-switch input for CCW rotation (left)
PC-AT Personal computer with 80x86 Processor
PELV Protected low voltage
PGND Ground for the interface
PSTOP Limit-switch input for CW rotation (right)
PWM Pulse-width modulation
RAM Volatile memory
Rregen Regen resistor
RBext External regen resistor
RBint Internal regen resistor
RES Resolver
ROD 426 A quad B encoder
PLC Programmable logic controller
SRAM Static RAM
SSI Synchronous serial interface
UL Underwriters Laboratory
VAC AC voltage
VDC DC voltage
VDE Verein deutscher Elektrotechniker
XGND Ground for the 24V supply