268
UNI Unison. The same note received on the input is
sent to the output.
NC No Change. The harmony voice will keep its pre-
vious pitch until the lead voice pitch changes to a
non “NC” note.
Copy to… button
Use this button to copy the current custom map to other voices.
When you touch the button, the Copy Custom Voice Mapping
dialog box appears:
Check all desired target voices, then touch OK to confirm the
copy.
Mic: Effects
This page allows to adjust the various effect parameters for the
Voice Pro cess or.
FX Mix
Lead to Delay knob
Lead to Delay effects send.
Harmony to Delay knob
Harmony to Delay effects send.
Reverb Level knob
Sets the overall volume of the Reverb effect.
FX Level knob
Sets the overall volume of the Delay effect.
Delay
Type
Use this parameter to select a Delay type.
Mono Mono delay.
Stereo Maintains the panning of the sends.
PingPong1 Sends the lead voice to the left effect end only.
PingPong2 Sends the lead voice to the sends depending on
the lead pan setting.
Delay
Only available when Src = Manual (see below). Use this parame-
ter to fine adjust (in milliseconds) the current delay time.
Feedback
Delay feedback amount.
Src (Source)
Use this parameter to set the source of the tempo for the delay.
MIDI Tempo is received from MIDI.
Manual The delay time is set using the “Delay” parameter.
R (Ratio)
Sets the ratio between the tempo and the resulting delay. For
example, “1:2” means that for each quarter note at the current
tempo, the delay plays two notes. A value of “1:4” means that for
each quarter note at the current tempo, the delay plays four
notes, and so on.
Hi Freq Damp (High Frequency Damping)
High Frequency Damping.
Reverb
Type
The list of reverb types includes the following acoustic simula-
tions.
Pre Delay
Reverb Pre-delay time. Sets the delay time prior to the reverb
output. Large rooms typically have reverbs that start much later
than the initial signal.
Reverb Time
Reverb Decay Time. Length or the Reverb.
Pre LEQ Gain
Reverb pre-equalization of the low frequencies. Specifies the
characteristics of the reverbs low frequencies.
Pre HEQ Gain
Reverb pre-equalization of the high frequencies. Specifies the
characteristics of the reverbs high frequencies.
Hall Smooth Hall
Wet Plate Dry Plate
Room Bright Room
Early Reflections
To Next Page
Loading...
Need help?
General
