90
Recording a new Song (Standard MIDI File)
Setting the Record parameters
Setting the Record parameters
When you enter Backing Sequence Record, the latest selected Style and Sounds are already selected,
and all tracks are ready to record. You could simply start recording as if you were playing in realtime
with the Styles. However, there are some further settings that you may want to do.
• If you like, adjust any editable parameter in the display.
Recording
1 Select the Style Element you wish to use before starting to play.
2 Start recording, by pressing the START/STOP button.
Note: If you do not wish
to start the Song with the
Style already playing, you
can simply start recording by
pressing the PLAY/
STOP button in the PLAYER 1
section, then start the Style
only at a later time. The Style
will start at the beginning of
the following measure.
3 Play as if you were performing live with the Styles.
During recording, select any Style Element (Intro, Variation, Break, Ending…) you like. You can
also press START/STOP to stop the Style, and press it again to start the Style again!
Please remember that, while recording in Backing Sequence Record mode, you cannot use the
SYNCHRO, TAP TEMPO/RESET, BALANCE controls.
Touch the Style parame-
ter (or the STYLE button)
to open the Style Select
window, and select a dif-
ferent Style.
Track(s) status. ‘Rec’ means they are ready to
record. ‘Play’ means they are recorded and you
can hear them. ‘Mute’ means they cannot be
heard.
Measure counter. The
negative number ( -1) is
the precount, after which
you can start recording.
Style’s Tempo. Change it,
if you like.
Grouped tracks. During Quick Record, you cannot access each separate Song
track. For ease of use, just two ‘master’ tracks are provided: Kbd/Pad (Key-
board/Pads) and Ch/Acc (Chord/Accompaniment).
Style’s Meter (or Time
Signature). It’s just an
indicator, you cannot
change it.
Touch the Perf/STS
parameter to open the
Performance Select win-
dow, and select a differ-
ent Performance (as seen
on page 45). As an alter-
native, you use the PER-
FORMANCE or STS
buttons.
Select any of the Variations before starting to record.
Select one of the Intros to start with an introduction.
To Next Page
Loading...
Need help?
General
