269
Global mode
Mic: Global Setup
Reference
Mic: Global Setup
In this page you can select a Voice Processor Preset, and set some
general parameters for your voice. These parameters are general
setting, that will not change when a different Preset is selected.
Setup
Global Voice Processor Preset
This VP Preset will be chosen when selecting a Performance or
STS making use of the global VP Preset, instead of a “local” one.
The use of a global VP Preset is shown in the Mic panel of the
main screen.
Lead Setting
Low Cut Frequency
A low-cut filter can be activated on the Lead Voice. This filter
allows for a cleaner signal from the microphone, by “cutting out”
pops, room rumble and mic handling noise.
Off No low-cut filter applied.
60, 80, 120Hz Filter set to different frequencies. The frequencies
below the set value are cut out.
Pan/Volume
Pan knob
Adjusts panning for the Lead voice. L64 (panned fully left) to
R63 (panned fully right).
Level knob
This parameter sets the Lead voice level.
Off Lead voice is turned off.
-30dB … 0dB Lead voice level.
Harmony Settings
Pitch Bend Range
Sets the range (in semitones) that pitch bend will alter the pitch
of the harmonies in Notes mode.
Talk
The Talk function can be used when having to address the audi-
ence, speaking over the background music.
Mic Talk button
On/off switch for the Talk function. This is the same switch you
can find in the Mic panel of the Style Play and Song Play modes.
This parameter is automatically set to off when turning the instru-
ment on.
Note: When you deactivate the Talk function, the Voice Processor
Preset is recalled. Any unsaved change to the Preset will be lost.
Auto (AutoTalk)
When this parameter is checked, the Talk function automatically
engages when the Player or Arranger is stopped. This way, you
can talk to the audience between two songs, without the need to
touch the Mic Talk button.
Master Volume Attenuation knob
Use this knob to set the volume level reduction of the back-
ground music when the Talk function is engaged. 0dB corre-
sponds to no level reduction.
Mic: Global Dynamics / EQ
In this page you can adjust parameters for the Compressor/Gate
and Equalizer, applied to the Lead and Harmony voices.
Assign
Dyn
Compressor/Gate assignment. The options are Off, Lead + Har-
mony, Harmony or Lead. The compressor has auto-makeup
gain, so there are no output levels problems when selecting a dif-
ferent option.
Dynamics
The Voice Processor has dynamics processing optimized for
vocals.
Threshold knob
Compressor Threshold. Range: 0 to -60 dB.
To Next Page
Loading...
Need help?
General
