102
Selecting elements
Performance Select window
Performance Select window
To open the Performance Select window, touch the Performance
area whereas it appears in the display, or one of the PERFOR-
MANCE buttons on the control panel. Use the PERFOR-
MANCE buttons to go directly to the selected bank.
Press EXIT to exit from this page and go back to the previous
page without selecting any Performance.
Note: Depending on the status of the “Auto Select” parameter (see
page 248), a Performance may be immediately selected when
pressing one of the PERFORMANCE buttons. The latest selected
Performance for that bank will be selected.
Side tabs (banks)
Use these tabs to select a bank of Performance. Each tab corre-
sponds to one of the PERFORMANCE buttons on the control
panel.
Lower tabs (pages)
Use these tabs to select one of the available pages in the selected
bank.
If you press again the same PERFORMANCE button on the con-
trol panel, the next page in the same bank is selected. This way,
you do not need to touch one of the corresponding tabs in the
display in order to select a different page.
Performances
Touch one of these buttons in the display to select a Perfor-
mance. Unless the “Display Hold” parameter (see page 248) is
turned on, the window automatically closes shortly after you
select a Performance.
Performance Select page menu
Touch the page menu icon to open the menu. Touch a command
to select it. Touch anywhere in the display to close the menu
without selecting a command.
The commands are the same seen for the Style Select window’s
page menu.
Pad Select window
Touch the Pad area whereas it appears in the display, to open the
Pad Select window.
Press EXIT to exit from this page and go back to the previous
page without selecting any Pad.
Pad sets
Selected set of Pads. Hit are single-note, pre-programmed fac-
tory Pads. Sequence are sequence-based, pre-programmed fac-
tory Pads. Local are like Factory Pads, but contain Pads
customized for the music of your Country. User can be either
single-note or sequence-based Pads, and can be user-created or
modified.
Side tabs (banks)
Use these tabs to select a bank of Pads.
Lower tabs (pages)
Use these tabs to select one of the available pages in the selected
bank.
Pad
Touch one of these buttons in the display to select a Pad. Unless
the “Display Hold” parameter (see page page 248) is turned on,
the window automatically closes short after you select a Pad.
Side tabs (banks)
Lower tabs (pages) Performances
Side tabs (banks)
Lower tabs (pages)
Pad sets
Pads
To Next Page
Loading...
Need help?
General
