262
Global mode
Audio & Video: MP3 / Speakers
Audio & Video: MP3 / Speakers
This page lets you define various parameters for the MP3 player
and the speakers.
MP3 Player
Volume
Use this parameter to set the maximum volume for the MP3
Player. This control lets you balance MP3 files against SMF
Songs and Styles.
0…100 Max volume in percentage.
Speakers
Speakers On/Off
Use this checkbox to turn the integrated speakers on or off.
Audio & Video: Limiter
The Limiter allows for an increased loudness of the MIDI tracks
(Styles and Songs), by compressing the signal exceeding a
defined threshold. MP3 files are not affected by the Limiter
(since they are usually already “produced”, and do not need to
pass through the Limiter again).
All these parameters can be saved into a Limiter Preset,
Limiter Preset
Use this pop-up menu to choose one of the available Limiter
Presets, and automatically reconfigure the EQ parameters.
On/Off
This is the on/off switch for the Limiter section.
Ratio
Sets the signal compression ratio. Compression is applied only
when the signal level exceeds the Threshold value. 1.0:1 means
no compression.
Threshold
Sets the level above which compression is applied. 0dB means no
signal processed.
Attack
Sets the attack time. A higher attack time will cause the compres-
sion to be applied more slowly, and not react fast enough for
notes with faster transients.
Release
Sets the release time. A higher release time will cause the com-
pression to be released more slowly; this may help sustaining
longer notes.
Gain Adjust
Sets the output gain. Use it to compensate for the gain loss
caused by compression.
Diagram
Use these indicators to check the level of the audio entering and
coming out of the Limiter.
•If the input level is too high, decrease the level of the Sounds,
Styles and/or Songs that are playing.
•If the output level is too high, decrease the level of the “Gain
Adjust” control.
To Next Page
Loading...
Need help?
General
