127
Style Play operating mode
Effects: IFX 1…3, Master 1…3
Reference
Effects: IFX 1…3, Master 1…3
These pages contain the editing parameters for the effect proces-
sors. Here is an example of the Master 1 page, with the Reverb
Wet Plate effe ct assi gned.
Selected effect
Select one of the available effects from this pop-up menu. This is
equivalent to the “FX Name” parameters found in the “Effects:
A/B FX Configuration” page (see above).
Note: Effects can be different for each one of the editing pages.
FX parameters
Parameters may be different, depending on the selected effect.
See the “Advanced Edit” addendum in the Accessory Disk for a
list of available parameters for each effect type.
Wet/Dry
Use this parameter to set the amount of the effect against the dry
signal coming from the track. This is the same setting found in
the “Mixer/Tuning: FX Send” page (see above).
Src (Source)
Modulation source. To select the track generating this message,
for Master FXs see the “M.T. (Modulating Track)” parameters
found in the “Effects: A/B FX Configuration” page (see above).
Modulating messages for the Insert FXs are generated by the
track the effect is applied to.
For a list of modulation source, see the “Advanced Edit” adden-
dum in the Accessory Disk.
Amt (Amount)
Volume of the effect, that is added to the dry (uneffected) signal.
Track Controls: Mode
This page lets you connect each track to the internal sound gen-
erator and to external MIDI devices. This is very useful to let a
Style track drive an external expander, or play a digital piano
with one of Pa3X’s Keyboard tracks. In addition, here you can set
the polyphony mode for each track.
Int./Ext. (Internal/External)
Internal The track plays the sounds generated by the
internal sound engine. It does not play an exter-
nal instrument connected to the MIDI OUT.
External The track plays an external instrument connected
to the MIDI OUT. The connected device must
receive on the MIDI channel associated with this
track on the Pa3X (see “MIDI: MIDI Out Chan-
nels” on page 212).
A track set to this status does not play the internal
sounds, therefore saving polyphony.
Instead of the assigned Sound name, the
<E: aaa.bbb.ccc> indicator is shown on a track’s
area in the Main page:
This indicator begins with a remark saying the
track is in External (”E”) mode, and continues
with a strings of transmitted Control Change and
Program Change data. This will let you know
what the track is transmitting to the MIDI OUT.
In the following example, CC#0 is the Control
Change 0 (Bank Select MSB), CC#32 is the Con-
Selected effect
FX parameters
FX group
SB
SB
SB
Control Change/Program Change area
To Next Page
Loading...
Need help?
General
