133
Style Play operating mode
Pad/Switch: Pad
Reference
Pad/Switch: Pad
This page lets you select a different hit sound or sequence for
each of the four PAD buttons.
Assignments can be saved into the current Style Setup or Song-
Book entry. The Pads share the B FX group with the Style tracks.
Note: You can also assign different Hits or Sequences from the Pad
panel of the main page.
Note: Each Style or SongBook entry can change the Pad assign-
ment.
Pad assignment
Name of the Hit or Sequence assigned to each Pad. Touch the
box to make the Pad Select window appear (see “Pad Select win-
dow” on page 105).
Volume
Volume for each of the four Pad tracks.
0…127 Volume level.
Pan
Pan for each of the four Pad tracks.
-64…-1 Left stereo channel.
0Center.
+1…+63 Right stereo channel.
FX Send (Master 1…3)
Send level to the Master FX processors for each of the four Pad
tracks.
0…127 Level of the Pad track (direct) signal sent to the
effect processor.
EQ Gain [dB] (Hi, Mid, Low)
Equalization for each of the four Pad tracks.
-18.0…+0.0…18.0
Gain value of the High, Middle, or Low band.
Pad lock icon
This lock avoids selecting a different Style or SongBook entry
changes also the Hit or Sequence Pads assigned to the Pads.
This lock is reset when turning the instrument off, unless you
write Global settings to memory (see “Write Global - Global
Setup dialog box” on page 220).
For more information on parameter locks, see “General Con-
trols: Lock” on page 204.
Pad/Switch: Switch
This page lets you select a different function for each of the three
ASSIGNABLE SWITCH buttons, located near the joystick.
Assignable Switches can be saved into a Performance, STS or
SongBook entry.
Switch 1-3
Each of the ASSIGNABLE SWITCH buttons. Use these pop-up
menus to assign a function to each switch. See “List of Assign-
able Switch functions” on page 241.
Assignable Switch lock icon
This lock avoids selecting a different Performance or STS
changes also the functions assigned to the switches.
This lock is reset when turning the instrument off, unless you
write Global settings to memory (see “Write Global - Global
Setup dialog box” on page 220).
For more information on parameter locks, see “General Con-
trols: Lock” on page 204.
Set
Set
Set
Gbl
Gbl
To Next Page
Loading...
