38
Turning the instrument on and listening to the demos
Turning the instrument on, and viewing the main screen
First of all, turn the instrument on and familiarize yourself with the main screen. You can also listen
to the demos.
Turning the instrument on, and viewing the main screen
1 Turn the Pa3X on by pressing the POWER button, located on the back panel, then the
STANDBY button located in the control panel.
Note: The POWER button
connects the Pa3X to the
power line, while the
STANDBY button turns it on.
After you turn the instrument on, a welcome screen is shown for a few seconds, and then the
main display appears.
2 When you want to turn the Pa3X off, keep the STANDBY button pressed for two sec-
onds, and put it in standby mode.
The preferred way to turn the Pa3X off is to put it in standby mode, so that the internal battery
will continue charging and preserve the Sample RAM content intact. If you prefer to save some
power, turn the Pa3X off by pressing the POWER button instead. Please note that in the latter
case the internal battery preserving the content of the Sample RAM will discharge in three-four
days, and loading PCM Samples with then take longer.
Turning the instrument on and listening to the demos
Power switch DisplayDemo buttons
Real Time (Keyboard) Tracks