204
Global edit mode
General Controls: Lock
General Controls: Lock
This page, split in four panes that can be selected by means of the
corresponding side tabs, contains all the available locks, some-
times grouped under just a single lock. Locks prevent parameter
values to be changed when loading data from a storage device, or
selecting a different Performance, Style or STS.
Locks
All the available locks. Lock them to prevent changes due to
loading or selecting different elements. These locks are also
found in various other pages, next to the locked parameter.
Hint: To save the status of the various parameters as a fixed status
for the Pa3X, save all the parameters to Performance 1 of Bank 1
(automatically selected when turning on the instrument), and save
these locks to the Global.
• Lock–Tuning pane
Master Transpose
When locked, master transpose is not automati-
cally changed when selecting a different Perfor-
mance or Style.
(See “Master transpose” on page 112).
Master Transpose from Performance
When closed, this lock prevents a Performance
change to modify the Master Transpose. When
open, changing a Performance may also change
the Master Transpose.
(See “Master transpose” on page 112).
Hint: In order to avoid having the Master Trans-
pose settings change when selecting a different
Style, use the general Master Transpose Lock (the
first parameter in this page).
Note: When the Master Transpose Lock is closed,
this parameter has no effect. However, the Master
Transpose Lock also locks the Performance Trans-
pose.
Master Transpose from Style Settings
When closed, this lock prevents a Style change to
modify the Master Transpose. When open,
changing a Style may also change the Master
Transpose.
(See “Master transpose” on page 112).
Hint: In order to avoid having the Master Trans-
pose setting change when selecting a new Perfor-
mance or STS, use the general Master Transpose
Lock (the first parameter in this page).
Note: When the Master Transpose Lock is closed,
this parameter has no effect. However, the Master
Transpose Lock also locks the Style Settings Trans-
pose.
Sub Scale/Quarter Tone
When locked, selecting a Performance or STS
will not change the Sub-Scale or Quarter Tone
value.
(See “Sub-Scale panel” on page 119).
SubScale/Quarter Tone from STS
When closed, this lock prevents an STS change to
modify the SubScale/Quarter Tone settings,
allowing for changing sounds and effects but not
the scale. When open, changing an STS may also
change these settings.
(See “Sub-Scale panel” on page 119).
Auto Octave This lock lets you decide if the instrument will
automatically transpose the Upper tracks when
turning the SPLIT button on and off.
• If On, when turning the SPLIT button or off,
the Upper tracks transposition is left unchanged.
• If Off, when turning the SPLIT button off (Full
keyboard mode), the Upper tracks Octave Trans-
pose is automatically set to “0”. When turning the
SPLIT button on (Split keyboard mode), the
Upper tracks Octave Transpose is automatically
set to “-1”.
• Lock–Control pane
Assignable Switches
When locked, selecting a Performance or STS
will not change the Assignable Switch assign-
ment.
(See “Pad/Switch: Switch” on page 133).
Slider Mode When locked, selecting a Performance or STS
will not change the selected status of the SLIDER
MODE button.
(See “SLIDER MODE” on page 8).
Split Point When locked, selecting a Performance or STS
will not change the split point.
(See “Split Point” on page 118).
To Next Page
Loading...
Need help?
General
