194
Sequencer operating mode
Song Edit: Delete
Song Edit: Delete
This page is where you can delete MIDI events from the Song.
After setting the various parameters, touch Execute to start the
operation.
Track
Use this parameter to select a track.
All All tracks selected.
Track 1…16 Selected track.
Master Master track. This is where the Tempo, Scale and
Effect events are recorded.
Event
Type of MIDI event to delete.
All All events. Measures will not be removed from
the Song, and will remain empty.
Note All notes in the selected range.
Dup.Note All duplicate notes. When two notes with the
same pitch are encountered on the same tick, the
one with the lowest velocity is deleted.
After Touch After Touch events.
Pitch Bend Pitch Bend events.
Prog.Change Program Change events, excluding the bundled
Control Change #00 (Bank Select MSB) and #32
(Bank Select LSB).
Ctl.Change All Control Change events, for example Bank
Select, Modulation, Damper, Soft Pedal…
CC00/32…CC127
Single Control Change events. Double Control
Change numbers (like 00/32) are MSB/LSB bun-
dles.
Start / End Tick
Use these parameters to set the starting and ending points of the
range to edit.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at 1.01.000,
and the End at 5.01.000.
Bottom / Top Note
Use these parameters to set the bottom and top of the keyboard
range to delete. If you select the same note as the Bottom and
Top parameters, you can select a single note, or a single percus-
sive instrument in a Drum track.
Note: These parameters are available only when the All or Note
options are selected.
Song Edit: Copy
Here you can copy tracks or phrases.
After setting the various parameters, touch Execute to start the
operation.
Note: If you copy too many events on the same “tick”, the “Too
many events!” message appears, and the copy operation is aborted.
Mode
Use this parameter to select the Copy mode.
Merge Copied data are merged with the data at the tar-
get position.
Overwrite Copied data replace all data at the target position.
War ni ng : Deleted data cannot be recovered!
From Track… To Track
Use these parameters to select the source and target track to
copy.
All All tracks. The target track cannot be selected.
Track 1…16 Selected source and target tracks.
Start Measure… End Measure
These parameters are the starting and ending measure to copy.
For example, if From Measure=1 and To Measure=4, the first
four measures are copied.
To Measure
This parameter is the first of the target measures.
Repeat Times
Number of times the copy must be executed. Copies will be con-
secutive.
To Next Page
Loading...
Need help?
General
