48
Playing Sounds
Raising or lowering the Upper octave
Raising or lowering the Upper octave
If all Upper tracks sound too high or too low, you can quickly change which octave they are playing
in.
1 Use the UPPER OCTAVE buttons on the control panel, to transpose all Upper tracks at
the same time.
Note: The Octave Trans-
pose value for each of the
keyboard track is shown
under the Sound’s name.
2 Press both UPPER OCTAVE buttons together to reset the octave to the value saved in
the current Performance.
Digital Drawbars
A special Sound in the Pa3X is the “Digital Drawbars”. This sound emulates the classic tonewheel
organs of the past. You can use the Assignable Sliders of the Pa3X to adjust the position of each draw-
bar, and then save these settings to a Performance (see “Saving your settings to a Performance” on
page 52).
1 Mute all Upper tracks, apart for the Upper 1 track. Select the Upper 1 track.
2 Touch the Sound name to open the Sound Select window.
Each press of this button will
lower the pitch by one octave.
Each press of this button will
raise the pitch by one octave.
The Upper 1 track is set to play
and selected.
Upper 2 and 3 tracks are
muted (they cannot be heard).
To Next Page
Loading...
Need help?
General
