150
Song Play operating mode
Switching between players during editing
Edit section
This identifies the current edit section, corresponding to one of
the items of the edit menu (see “Edit menu” on page 149).
Page menu icon
Touch this icon to open the page menu (see “Page menu” on
page 158).
Parameters area
Each page contains various parameters. Use the tabs to select
one of the pages. For detailed information on the various types
of parameters, see sections starting below.
Tabs
Use tabs to select one of the edit pages of the current edit section.
Switching between players during editing
When you enter Edit mode, you can edit the parameters of the
selected Player. The selected Player is always shown on the page
header.
To select a player, go to the main page of the Song Play mode,
and select the players you wish to edit. The selected player is
shown with a white background.
Mixer/Tuning: Volume/Pan
This page lets you set the volume and pan for each of the Key-
board or Song tracks.
Note: Song parameters cannot be saved when saving to a Perfor-
mance or STS.
Note: The play/mute status of a Song track may be reset when
selecting a Song made on a Pa-Series instrument.
Use the TRACK SELECT button to switch from the Keyboard to
the Song tracks, and vice versa.
Upper Volume Link
This parameter allows you to define if changing the volume for
one of the Upper tracks, proportionally changes also the volume
for the other Upper tracks.
To save this parameter’s status, go to the Style Play mode, then
select the Write Global-Style Play Setup from the page menu (see
“Write Global-Style Play Setup dialog box” on page 139).
Note: This parameter is the same you can find in the “Preferences:
Style Play Setup” page of the Style Play mode (see page 137).
On When changing volume to one of the Upper
tracks, volume for the other Upper tracks changes
in proportion.
Off When changing volume to one of the Upper
tracks, only that track’s volume is changed. Other
Upper tracks are left unchanged.
Dry
Use this checkbox to turn the dry (direct) track signal on or off
from the Master FX Send. To hear the direct signal, also set the
FX Send Level of the relevant Master FX to a value different than
zero (see “Mixer/Tuning: FX Send” below).
To Next Page
Loading...
Need help?
General
