5-6
Operation on the Machine > Program
Program
By registering sets of frequently used functions as a single program, you can simply press one of the [
Program I
] to
[
Program IV
] keys as needed to recall those functions.
The following functions are already registered in [
Program I
] key. This function allows you to copy the front and back
sides of ID card or other document that is smaller than Statement or A5 size onto a single page. Although the functions
are deleted by overwriting [
Program I
] key, you can register the same settings using the [
Function Menu
] key.
• Paper Selection: Cassette 1
• Zoom: Auto
• Combine: 2 in 1
• Original Size: Statement (Inch models)/A5 (Metric models)
• Continuous Scan: On
[
ID Card Copy
] is printed on the [
Program I
] key.
Registering Programs
Use the procedure below to register a program.
1
Configure the settings of the functions.
Configure the settings of the functions you want to register in a program.
For the settings of functions, refer to Using Various Functions on page 6-1
.
• It is possible to register the copy function, sending function and fax function in a program. (The fax function can be
registered or recalled only on products with the fax function installed).
• If user login administration is enabled, you can only register functions by logging in with administrator privileges.
To Next Page
Loading...
