6-20
Using Various Functions > Functions
File Name Entry
Adds a file name. Additional information such as job number and date and time can also be set. You can check a job
history or job status using the file name, date and time, or job number specified here.
Enter the file name (up to 32 characters), and press the [
OK
] key.
To add date and time, select [Date]. To add job number, select [Job No.]. To add both, select [Job No. + Date] or
[Date + Job No.]. Then press the [
OK
] key.
Print Override
Suspends the current job and gives a new job top priority. The suspended job resumes after the other job is finished.
(
Value
: [Off] / [On])
Quiet Mode
Lower print and scan speed for quiet processing. Select this mode when the running noise is uncomfortable.
It is possible to set the use of Quiet Mode for each function, such as copying and sending.
(
Value
: [Off] / [On])
• This function is not available if current job was an override.
• Print override may not be available depending on the status of the current print job and memory usage.
• The processing speed will be slower than normal when in Quiet Mode.
• This cannot be used when [Prohibit] is set for Each Job on page 8-38
.
To Next Page
Loading...
