9-18
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
Group Auth. (Group Authorization Settings)
Set restrictions of the machine usage by each individual group registered in the authentication server.
1
Display the screen.
1
Press the [
System Menu/Counter
] key.
2
Press the [
▲
] or [
▼
] key to select [User/Job Account], and press the [
OK
] key.
3
Press the [
▲
] or [
▼
] key to select [User Login Set.], and press the [
OK
] key.
2
Configure the setting.
1
Press the [
▲
] or [
▼
] key to select [Group Auth.], and press the [
OK
] key.
2
Press the [
▲
] or [
▼
] key to select [Off] or [On], and press the [
OK
] key.
• To use the group authorization settings, [Netwk Authentic.] must be selected for the authentication method in
Enabling User Login Administration on page 9-3
. Select "On" for "LDAP" in Protocol Detail on page 8-9.
• Setting to use group authorization is performed from the operation panel. The groups should be registered with
Command Center RX. For details, refer to the
Command Center RX User Guide
.
If the login user name entry screen appears during operations, enter a login user name
and password, and press [Login].
The factory default login user name and login password are set as shown below.
Sys. Menu/Count.:
User/Job Account
Exit
04
Counter
03
02
System/Network
Login User Name Login Password
4000 4000