Kyocera ECOSYS M3040dn

8-8
Setup and Registration (System Menu) > System Menu
System/Network
Configure machine system settings.
Network Setting
Configure network settings.
TCP/IP Settings
NOTE
This function is displayed when the optional Network Interface Kit is installed.
System/Network Network Setting TCP/IP Settings
Item Description
TCP/IP
Settings
TCP/IP Select whether to use TCP/IP Protocol.
Value: Off, On
IPv4 Setting Set up TCP/IP (IPv4) to connect to the network. This setting is available when
[TCP/IP] is set to [On].
DHCP Select whether to use the DHCP (IPv4) server.
Value: Off, On
Auto-IP Select whether to use Auto-IP.
Value: Off, On
IP Address Set the IP addresses.
Value: ###.###.###.###
NOTE
If DHCP is set to [On], this item is displayed only and cannot be entered.
Subnet Mask Set the IP subnet masks.
Value: ###.###.###.###
NOTE
If DHCP is set to [On], this item is displayed only and cannot be entered.
Default Gateway Set the IP gateway addresses.
Value: ###.###.###.###
NOTE
If DHCP is set to [On], this item is displayed only and cannot be entered.
IPv6 Setting Set up TCP/IP (IPv6) to connect to the network. This setting is available when
[TCP/IP] is [On].
Select whether to use IPv6.
Value: Off, On
NOTE
The IPv6 settings are configured from the Command Center RX. Refer to the
Command Center RX User Guide .
Bonjour Select whether to use Bonjour.
Value: Off, On