2RV/2RW/2RX/2RY/3RA
6-11
Contents
Writing data in a USB memory.
Executable only when a USB memory is detected.
Method
Insert a USB memory before writing data.
1. Enter the Service Setting menu.
2. Using the [▲] or [▼] key, select [Write Data].
3. Press the [OK] key.
4. Press the [OK] key.
5."Data waiting" is displayed when becoming ready to receive the write data.
6. "Processing" appears and writing data in a USB memory is executed by sending data from the
host in this status. "Ready" is displayed after completion.
Completion
Press the [Menu] key.
Contents
Reset the counter after replacing the maintenance kit.
The "Replace MK" message indicates that it is necessary to replace the maintenance kit when
the specified print count has been reached. After replacing the maintenance kit, execute this item
and reset the counter in order to newly start the count.
* :Appears in the system menu only at the time of replacement.
Purpose
Clears maintenance kit life counts.
Replacement procedures
Drum unit (See page 4-11)
Developer unit (See page 4-10)
Method
1. Enter the Service Setting menu.
2. Using the [▲] or [▼] key, select [Maintenance].
3. Press the [OK] key.
4. Press the [OK] key.
5. "Completed" appears and the counter of the each unit is reset.
Remarks
The counter reset at the maintenance kit replacement is recorded in the event log as the page or
image count at the maintenance kit replacement (6-16,6-19 reference). Base on this information,
it can be judged that it was reset at other timing than the maintenance kit replacement.
Write Data
Maintenance
To Next Page
Loading...
Need help?
General
Weight and Dimensions
