2J0/2J1/2J2
1-6-3
(2) Downloading the firmware from the memory card
To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.
CAUTION
Downloading firmware takes several minutes. Do not turn power off during downloading. If downloading is interrupted by
an accidental power failure, etc., the main PWB may have to be replaced.
1. Turn printer power off.
2. Remove two screws and then remove the
optional interface slot cover.
3. Insert the memory card into the printer's
memory card slot.
Figure 1-6-4
4. Turn printer power on.
5. Press MENU key on the printer's operation
panel and carry out the memory card for-
matting procedure (1).
6. When formatting is complete, turn printer
power off.
Figure 1-6-5
Memory card slot
Memory card
Screw
Screw
Optional interface
slot cover
Message display
(1)
Memory Card >
>Format
>Format ?
Processing
Press the key.
Press the MENU key.
Press the or key.
Press the or key.
Press the OK key.
Press the OK key.
Ready
Ready
Operation panel keys
(Format information is
automatically printed.)