Kyocera TASKalfa 650c

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 109
7 COMMAND CENTER ADMINISTRATOR MODE
6
Click [OK] to apply the changes.
This equipment starts initializing the network interface card to apply the changes
During the initialization of the network interface card, the network will not be available. COMMAND CENTER
will display “Please restart after waiting a few minutes.” During the initialization, the touch panel will display
“NETWORK INITIALIZING”. When this message disappears, COMMAND CENTER will once again be
available.
 Setting up TCP/IP
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be configured to enable
COMMAND CENTER, SMB printing, Raw TCP or LPR printing, IPP printing, Save as file to network folder, Scan to Email,
and Internet Fax.
1) Ethernet Speed Duplex Mode
Select the ethernet speed.
 When you select a specific ethernet speed, you must select the same ethernet speed as set in the connected
network. If you do not know the ethernet speed that must be used, select [AUTO].
 If the network is not stable, power OFF the equipment then ON.
2) Address Mode
Select how to set the IP address.
- Static IP — Select this to assign the static IP address manually. When this is selected, enter the static IP address
in the [IP Address] box.
- Dynamic
— Select this to assign the IP address using the DHCP with Auto-IP addressing enabled. When this is
selected, the IP address, subnet mask, default gateway, primary WINS server address, secondary WINS server
address, POP3 server address, and SMTP server address can be automatically obtained from the DHCP server if
the network supports the DHCP, and the IP address can be also assigned using Auto-IP addressing even if the
network does not support the DHCP.
- No AutoIP — Select this to assign the IP address using the DHCP with Auto-IP addressing disabled. When this is
selected, the IP address, subnet mask, default gateway, primary WINS server address, secondary WINS server
address, POP3 server address, and SMTP server address can be automatically obtained from the DHCP server if
the network supports the DHCP, but the last IP address will not be used if the equipment cannot communicate with
the DHCP server.
1
2
3
4
5
6
7
8
9
10
11
12