Kyocera TASKalfa 650c - Page 112

7 COMMAND CENTER ADMINISTRATOR MODE
110 Setting up From COMMAND CENTER
3) Obtain a Domain Name automatically
Select [Enable] when you want to obtain a domain name automatically using the DHCP server. This setting will apply
only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a domain name, the data are left blank in the domain name even if you set
the correct domain name manually in the DDNS Session. In that case, select [Disable] here and set the correct
domain name in the DDNS Session.
 P.117 “Setting up DDNS Session”
4) Obtain a Domain Server Address automatically
Select [Enable] when you want to obtain a domain server address automatically using the DHCP server. This setting
will apply only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a primary and secondary DNS server addresses, the data are left blank in
the primary and secondary DNS server addresses even if you set the correct primary and secondary DNS server
addresses manually in the DNS Session. In that case, select [Disable] here and set the correct primary and
secondary DNS server address in the DNS Session.
 P.116 “Setting up DNS Session”
5) Obtain a WINS Server Address automatically
Select [Enable] when you want to obtain a primary or secondary WINS server address automatically using the DHCP
server. This setting will apply only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a primary and secondary WINS server addresses, the data are left blank in
the primary and secondary WINS server addresses even if you set the correct primary and secondary WINS server
addresses manually in the SMB Session. In that case, select [Disable] here and set the correct primary and
secondary WINS server address in the SMB Session.
 P.119 “Setting up SMB Session”
6) Obtain a SMTP Server Address automatically
Select [Enable] when you want to obtain a SMTP server address automatically using the DHCP server. This setting will
apply only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a SMTP server address, the data are left blank in the SMTP server address
even if you set the correct SMTP server address manually in the SMTP Client. In that case, select [Disable] here
and set the correct SMTP server address in the SMTP Client.
 P.123 “Setting up SMTP Client”
7) Obtain a POP3 Server Address automatically
Select [Enable] when you want to obtain a POP3 server address automatically using the DHCP server. This setting will
apply only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a POP3 server address, the data are left blank in the POP3 server address
even if you set the correct POP3 server address manually in the POP3 Network Service. In that case, select
[Disable] here and set the correct POP3 server address in the POP3 Network Service.
 P.126 “Setting up POP3 Network Service”
8) Obtain a SNTP Server Address automatically
Select [Enable] when you want to obtain a SNTP server address automatically using the DHCP server. This setting will
apply only when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
When the DHCP server does not have a SNTP server address, the data are left blank in the SNTP server address
even if you set the correct SNTP server address manually in the SNTP Network Service. In that case, select
[Disable] here and set the correct SNTP server address in the SNTP Network Service.
 P.129 “Setting up SLP”