7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 147
7 COMMAND CENTER ADMINISTRATOR MODE
3
Click [OK].
The user certificate for IEEE802.1X is imported.
If you want to enable CRL Verification, go to the next step. If not, go to step 6.
This alert message shows that you must enter a password on the control panel of this equipment after you
installed the user certificate for IEEE802.1X. The certificate cannot be used unless you enter a password.
4
Select either of [CRL file (PEM)] and [CRL file (DER)] according to the format of a CRL
file that you want to use. Then click [Browse..] to specify a CRL file to be uploaded, and
then click [Upload].
The selected CRL file is uploaded.
5
Select [Enable] of [CRL Verification].
To Next Page
Loading...
