7 COMMAND CENTER ADMINISTRATOR MODE
148 Setting up From COMMAND CENTER
6
Select [Import], and then click [Previous] to close the Security Service page.
7
Click [Save] on the Network submenu page.
8
You must enter a password for user certificate on the control panel of this equipment
before setting up the IEEE802.1X.
For instructions on how to input the password, refer to the following section in the MFP Management Guide.
Chapter 2 “SETTING ITEMS (ADMIN)”
- “Setting Network Functions”
- “Decrypting the user certificate”
9
Then you can enable IEEE802.1X for the following settings.
For instructions on how to enable the IEEE802.1X, refer to the following section in the MFP Management Guide.
Chapter 2 “SETTING ITEMS (ADMIN)”
- “IEEE 802.1X Authentication Setting”
Deleting an imported user certificate for IEEE802.1X
You cannot delete a user certificate for IEEE802.1X being used.
1
Click [Security Service].
The Security Service page is displayed.
To Next Page
Loading...
