7.COMMAND CENTER ADMINISTRATOR MODE
Setting up User Management 267
7 COMMAND CENTER ADMINISTRATOR MODE
Enabling MFP Local Authentication
When no network authentication system is configured in your network, you can enable MFP Local Authentication.
MFP Local Authentication uses the account information that is registered in this equipment for authentication. Therefore,
you must register the user account information first before enabling MFP Local Authentication. This equipment also
manages the counters for each user if MFP Local Authentication is enabled.
P.270 “Creating or modifying user information”
After you register the user information, enable MFP Local Authentication.
P.267 “Enabling MFP Local Authentication”
Enabling MFP Local Authentication
1
Click the [User Management] tab and the [Authentication] menu.
The login page is displayed.
2
Enter the administrator password and click [Login].
The Authentication page is displayed.
3
Click [User Management Setting].
The User Management Setting page opens.
To Next Page
Loading...
