7 COMMAND CENTER ADMINISTRATOR MODE
268 Setting up User Management
4
Select the [MFP Local Authentication] box, and select how invalid jobs are processed
in the [User Authentication Enforcement] box. Then click [Next].
The confirmation dialog box appears.
If you want to enable guest user operations, select the [Enable Guest User] check box. Go to the next step.
5
Click [OK].
6
Select the [MFP Local Authentication] box, and select how invalid jobs are processed
in the [User Authentication Enforcement] box. Then click [Next].
In the [User Authentication Enforcement] box, select whether invalid jobs, for which authentication has failed, are
printed or stored in the invalid job list.
ON
— Select this to not print the invalid jobs and store them in the invalid job list.
Print — Select this to print the invalid jobs.
Delete — Select this to delete the invalid jobs without storing them in the invalid job list.
You can disable the User Management Setting by selecting [Disable] and click [Next].
If you use your Card ID as a user name, select the [Use Card ID for User Name] check box.This checkbox
is displayed only when the card was authenticated.
If you changed the setting, you must register the new user information. To register new user information, delete
all the user information on the [User Management] tab page and then register the new user information.
P.273 “Deleting all user information”
P.279 “Importing user information”
To Next Page
Loading...
